SuttonAppliance Engineers

Why a washer dryer leaves clothes damp

The five reasons a washer dryer stops drying properly, in the order an engineer would check them.

By the engineers at Sutton Appliance Engineers. Updated November 2026.

Washer dryers dry less than they wash. The first check is always the load: most machines dry only half to two-thirds of their wash capacity, and a full drum of towels will stay damp however long it runs.

If the load is right

  • Clothes hot and wet: the condenser duct is blocked with fluff and steam cannot escape.
  • Clothes cold and wet: the heater, a thermostat or the fan has failed.
  • Cycle stops early: a sensor fault, or the machine could not drain.
  • Drying takes twice as long as it used to: partial blockage, which will become total.

What you can do

Make sure the cold tap is on, since many models condense with water. Run a rinse-and-spin to prove the drain works. Beyond that the duct sits over the tub under the lid, and clearing it is an engineer's job because of the heater and its wiring.

Book a repair visit

Tell us the make, the model and what the appliance is doing. An engineer visits, finds the fault and agrees the price with you before repairing it.

Visits run Monday to Thursday across Sutton and the surrounding SM postcodes.