SuttonAppliance Engineers

Extractor hood repairs

Chimney, canopy, integrated and island hoods. A hood that lights up but will not pull air is normally a motor or a switch.

Call 0208 462 2111Book online

Engineer working on a stainless steel extractor hood above a range cooker

Extractor motors work in warm, greasy air and eventually seize or lose a capacitor. Switches and light transformers are the other regular failures.

Tell us whether the hood vents outside or recirculates through carbon filters, and whether it is fixed to the wall or built into a cupboard.

Engineer working on a stainless steel extractor hood above a range cooker

Extractor hood faults and how we repair them

Extractor hood with the fault locations numbered1234567
Extractor hood drawing. The numbers match the faults listed alongside.
  1. 1Lights work but no extraction

    Likely cause. A seized motor or a failed motor capacitor.

    What you can check. Remove the grease filters and see whether the fan turns freely by hand with the power off.

    What we do. We replace the capacitor or motor.

  2. 2Loud or rattling

    Likely cause. A fan wheel fouling its housing, or worn motor bearings.

    What you can check. Check the filters are clipped in. Loose filters rattle.

    What we do. We refit or replace the fan and motor.

  3. 3Lights do not work

    Likely cause. Blown lamps, a failed transformer or LED driver, or a bad switch.

    What you can check. Try a new lamp of the same type and wattage.

    What we do. We test the lighting circuit and replace the driver or switch.

  4. 4Buttons or slider not responding

    Likely cause. A worn switch bank or a failed touch control board.

    What you can check. See if any speed works. It tells us which part has gone.

    What we do. We fit a new switch unit or control board.

  5. 5Poor suction although the fan runs

    Likely cause. Clogged filters, saturated carbon filters or a crushed duct.

    What you can check. Hold a sheet of kitchen paper to the filter. It should cling at top speed.

    What we do. We check the duct run and non-return flap and advise on filters.

  6. 6Water drips from the hood

    Likely cause. Condensation running back down a long cold duct.

    What you can check. Leave the hood running for ten minutes after cooking.

    What we do. We check the duct fall and flap and suggest a remedy.

  7. 7Stuck on one speed

    Likely cause. A failed speed switch or control board relay.

    What you can check. Switch off at the wall for a minute to reset the control.

    What we do. We replace the switch or board.

Makes of extractor hood we repair

Extractor hood repairs near you

Related guides

Questions we are asked

How often should carbon filters be changed?

Every four to six months with regular cooking. They cannot be washed.

Can you replace an extractor motor?

Yes, where the maker still supplies it. Bring the model number and we will check before the visit.

Do you install new hoods?

Our visits are for repairs to existing hoods.

Why is my hood noisier than it used to be?

Grease on the fan wheel puts it out of balance. It is often cured by cleaning or replacing the wheel.

Book a repair visit

Tell us the make, the model and what the appliance is doing. An engineer visits, finds the fault and agrees the price with you before repairing it.

Visits run Monday to Thursday across Sutton and the surrounding SM postcodes.