SuttonAppliance Engineers

Washer dryer repairs

A washer dryer is two machines in one cabinet, so it has more to go wrong. The drying side is where most faults start.

Call 0208 462 2111Book online

Washer dryers condense steam using cold water, and the condenser duct slowly fills with wet fluff. When clothes come out hot but damp, that duct is the first place we look.

The washing side fails in the same ways as any front loader. Tell us whether the fault is on the wash, the dry, or both, and what is on the display.

Washer dryer fitted under a wooden worktop in a kitchen

Washer dryer faults and how we repair them

Washer dryer with the fault locations numbered1234567
Washer dryer drawing. The numbers match the faults listed alongside.
  1. 1Washes but will not dry

    Likely cause. A failed drying heater or thermostat, or a fan motor that has stopped.

    What you can check. Check you have selected a drying programme and not just a spin.

    What we do. We test the heater, thermostats and fan in the drying duct and replace the failed part.

  2. 2Clothes come out hot and damp

    Likely cause. The condenser duct is choked with fluff, so steam has nowhere to go.

    What you can check. Run a rinse with the drum empty. If water sits in the drum the drain needs attention first.

    What we do. We strip and clear the duct and condenser chamber, which restores proper drying.

  3. 3Will not drain

    Likely cause. A blocked pump or outlet hose. The dryer side also needs the drain to work.

    What you can check. Look at the outlet hose for kinks where it meets the waste pipe.

    What we do. We clear or replace the pump and check the hose route.

  4. 4No spin

    Likely cause. Belt, brushes or motor control, or an unbalanced load.

    What you can check. Try a smaller mixed load.

    What we do. We test the drive and replace the worn part.

  5. 5Leaks during the dry cycle

    Likely cause. A split duct seal or a blocked condenser sending water the wrong way.

    What you can check. Note whether the water appears on wash or on dry. It helps the diagnosis.

    What we do. We reseal or replace the duct and clear the blockage that caused it.

  6. 6Door stays locked

    Likely cause. Interlock failure, or the drum still too hot to release.

    What you can check. Leave it ten minutes after a drying cycle before trying again.

    What we do. We release the door and fit a new lock if it has failed.

  7. 7Stops with a code

    Likely cause. A sensor reading out of range, most often temperature or water level.

    What you can check. Write down the exact code or light pattern before switching off.

    What we do. We read the fault memory and test the component it points to.

Makes of washer dryer we repair

Washer dryer repairs near you

Related guides

Questions we are asked

Why does my washer dryer take so long to dry?

Condenser drying is slower than a separate dryer, but three hours or more for a half load means the duct is partly blocked.

Is a washer dryer harder to repair than a washing machine?

It takes longer because the drying duct sits over the tub, but the parts are readily available for the main makes.

Can I just use it as a washing machine?

Yes. A drying fault does not stop the wash programmes on most models, so you can carry on washing until we visit.

Does drying use water?

Most washer dryers do, to condense the steam. If the cold tap is off the dry cycle will fail.

Book a repair visit

Tell us the make, the model and what the appliance is doing. An engineer visits, finds the fault and agrees the price with you before repairing it.

Visits run Monday to Thursday across Sutton and the surrounding SM postcodes.