SuttonAppliance Engineers

Washing machine repairs in Morden

We repair washing machines throughout Morden, whatever the make.

Call 0208 462 2111Book online

Engineer working at the open door of a washing machine

Kitchens on the St Helier estate are small, so a single washing machine or washer dryer under the worktop is usual.

Tell us the make, the model number from the door rim and what the machine does when it stops. That is normally enough for the engineer to arrive with the likely part already on the van.

A large part of the area is the St Helier estate, built in the 1930s with compact kitchens. Elsewhere there are roomier semis towards Lower Morden and Morden Park.

Washing machine faults we are called to in Morden

Washing machine with the fault locations numbered12345
Washing machine drawing. The numbers match the faults listed alongside.
  1. 1Cold wash, or trips the fuse board

    Likely cause. A heater element that has scaled up and failed to earth, or a faulty temperature sensor.

    What you can check. If the electrics trip, leave the machine unplugged until it has been tested.

    What we do. We insulation-test the heater, replace it with the sensor if needed and re-test for safety.

  2. 2Drum turns slowly or will not spin

    Likely cause. Worn motor brushes, a slipped or split drive belt, or a load the machine cannot balance.

    What you can check. Try a spin with a few towels. A single heavy item such as a bath mat will often refuse to spin.

    What we do. We check belt, brushes and motor control, and replace what has worn.

  3. 3Water on the floor

    Likely cause. A torn door gasket, a perished hose, a blocked soap drawer overflowing, or a leaking pump seal.

    What you can check. Look for a tear in the grey door seal at the bottom, and pull the drawer out to see if it is caked.

    What we do. We trace the leak with the top and back off rather than guessing, then replace the failed seal or hose.

  4. 4Loud rumble on spin

    Likely cause. Drum bearings that have let water in. The noise gets worse month by month.

    What you can check. Turn the empty drum by hand. Grinding or play up and down points to bearings.

    What we do. We confirm it and price the job honestly. On sealed-tub machines we will say if it is not worth doing.

  5. 5Will not fill

    Likely cause. A closed tap, a blocked inlet filter or a failed inlet valve.

    What you can check. Make sure the tap on the cold feed is fully open and the hose is not trapped.

    What we do. We clean the inlet filter, test the valve coil and pressure switch, and replace the faulty part.

By make

Also in Morden

Nearby

More about washing machine repairs

Questions we are asked

Do you charge extra to come to Morden?

Morden is inside our normal working area. The engineer finds the fault on the visit and agrees the cost of the repair with you before starting.

Why does my machine smell?

Low-temperature washes leave residue in the seal and drawer. A monthly empty 60 or 90 degree wash and a wipe of the gasket usually cures it.

Can you repair an integrated washing machine?

Yes. Say it is built in when you book so that time is allowed to take the door off and slide the machine out.

Book a repair visit

Tell us the make, the model and what the appliance is doing. An engineer visits, finds the fault and agrees the price with you before repairing it.

Visits run Monday to Thursday across Sutton and the surrounding SM postcodes.