SuttonAppliance Engineers

Tumble dryer repairs in Beddington

Tumble dryer repairs in Beddington (SM6 and CR0), carried out in your home by an independent family firm.

Call 0208 462 2111Book online

Engineer servicing a tumble dryer with its lower filter panel removed

A converted garage or side extension often serves as the utility room in Beddington, with washer and dryer side by side.

Tell us which type you have. If there is a water bottle to empty it is a condenser or heat pump dryer. If there is a hose to a window or wall it is vented.

We visit Beddington and South Beddington, in SM6 and the neighbouring part of CR0.

Tumble dryer faults we are called to in Beddington

Tumble dryer with the fault locations numbered12345
Tumble dryer drawing. The numbers match the faults listed alongside.
  1. 1Empty-water light stays on

    Likely cause. A blocked pump or float in the base, so the bottle never fills.

    What you can check. Empty the bottle and check it is pushed fully home.

    What we do. We clear the sump and pump, or replace the pump if it has seized.

  2. 2Takes hours to dry

    Likely cause. Restricted airflow: a clogged condenser, a blocked heat pump filter or a crushed vent hose.

    What you can check. On heat pump dryers, wash the lower foam filter and let it dry before refitting.

    What we do. We strip and clean the air path and test the humidity sensor.

  3. 3Drum does not turn

    Likely cause. A snapped drive belt, a seized tension pulley or a failed motor capacitor.

    What you can check. With the dryer off, turn the drum by hand. If it spins with no resistance the belt has gone.

    What we do. We fit a new belt and check pulley and motor while the cabinet is open.

  4. 4Squeak, rumble or thump

    Likely cause. Worn drum rollers, a dry rear bearing or flattened felt seals.

    What you can check. Note whether the noise is constant or once per turn.

    What we do. We replace bearings, rollers or glides so the drum runs true again.

  5. 5Stops after a few minutes

    Likely cause. Overheat cut-out operating, or a moisture sensor reading dry too early.

    What you can check. Wipe the two metal sensor strips inside the drum with white vinegar.

    What we do. We test the cut-outs and control and correct the cause.

By make

Also in Beddington

Nearby

More about tumble dryer repairs

Questions we are asked

Do you charge extra to come to Beddington?

Beddington is inside our normal working area. The engineer finds the fault on the visit and agrees the cost of the repair with you before starting.

Why are my clothes still damp at the end?

Sensor programmes stop when the strips read dry. Fabric softener film on the sensors is a common cause.

Is my dryer part of a safety recall?

Some older Hotpoint, Indesit and Creda dryers were recalled. Check the model on the maker's site. We repair dryers but cannot carry out a manufacturer's recall modification.

Book a repair visit

Tell us the make, the model and what the appliance is doing. An engineer visits, finds the fault and agrees the price with you before repairing it.

Visits run Monday to Thursday across Sutton and the surrounding SM postcodes.