Washing machine repairs in Belmont
An engineer for your washing machine in Belmont: fault found, price agreed, repair done.

Bungalows in Belmont often have the washing machine in the kitchen and a vented dryer in a lean-to or garage.
Most of the machines we open in Sutton have failed in one of four places: the drain pump, the door lock, the heater or the motor. None of those is a reason to scrap a machine that is otherwise sound.
Belmont sits on the rising ground south of Sutton, around its own small station and the shops of Station Road, with the Royal Marsden close by.
Washing machine faults we are called to in Belmont
1Loud rumble on spin
Likely cause. Drum bearings that have let water in. The noise gets worse month by month.
What you can check. Turn the empty drum by hand. Grinding or play up and down points to bearings.
What we do. We confirm it and price the job honestly. On sealed-tub machines we will say if it is not worth doing.
2Cold wash, or trips the fuse board
Likely cause. A heater element that has scaled up and failed to earth, or a faulty temperature sensor.
What you can check. If the electrics trip, leave the machine unplugged until it has been tested.
What we do. We insulation-test the heater, replace it with the sensor if needed and re-test for safety.
3Water on the floor
Likely cause. A torn door gasket, a perished hose, a blocked soap drawer overflowing, or a leaking pump seal.
What you can check. Look for a tear in the grey door seal at the bottom, and pull the drawer out to see if it is caked.
What we do. We trace the leak with the top and back off rather than guessing, then replace the failed seal or hose.
4Drum turns slowly or will not spin
Likely cause. Worn motor brushes, a slipped or split drive belt, or a load the machine cannot balance.
What you can check. Try a spin with a few towels. A single heavy item such as a bath mat will often refuse to spin.
What we do. We check belt, brushes and motor control, and replace what has worn.
5Will not fill
Likely cause. A closed tap, a blocked inlet filter or a failed inlet valve.
What you can check. Make sure the tap on the cold feed is fully open and the hose is not trapped.
What we do. We clean the inlet filter, test the valve coil and pressure switch, and replace the faulty part.
By make
- Bosch washing machines
- Siemens washing machines
- Neff washing machines
- Miele washing machines
- AEG washing machines
- Zanussi washing machines
- Electrolux washing machines
- Hotpoint washing machines
- Indesit washing machines
- Whirlpool washing machines
- Beko washing machines
- Blomberg washing machines
- Samsung washing machines
- LG washing machines
- Hoover washing machines
- Candy washing machines
- Haier washing machines
- Hisense washing machines
- Smeg washing machines
- Lamona washing machines
- CDA washing machines
Also in Belmont
Nearby
Questions we are asked
How soon can someone look at my washing machine in Belmont?
We are in the Belmont area on visit days from Monday to Thursday. Call 0208 462 2111 for the earliest slot, and have the model number to hand.
Can you repair an integrated washing machine?
Yes. Say it is built in when you book so that time is allowed to take the door off and slide the machine out.
Is an eight-year-old washing machine worth repairing?
Often, yes. Pumps, locks, heaters and brushes are modest parts. Bearings on a sealed tub are the usual point at which we advise replacing instead.