SuttonAppliance Engineers

Washing machine repairs in Cheam

Washing machine repairs in Cheam (SM3), carried out in your home by an independent family firm.

Call 0208 462 2111Book online

Engineer working at the open door of a washing machine

Utility rooms are common in Cheam, with a separate washing machine and heat pump dryer stacked or side by side.

Tell us the make, the model number from the door rim and what the machine does when it stops. That is normally enough for the engineer to arrive with the likely part already on the van.

Cheam is built around the village crossroads and its timber-fronted shopping parades, with Nonsuch Park on one side and Cheam Park on the other.

Washing machine faults we are called to in Cheam

Washing machine with the fault locations numbered12345
Washing machine drawing. The numbers match the faults listed alongside.
  1. 1Drum turns slowly or will not spin

    Likely cause. Worn motor brushes, a slipped or split drive belt, or a load the machine cannot balance.

    What you can check. Try a spin with a few towels. A single heavy item such as a bath mat will often refuse to spin.

    What we do. We check belt, brushes and motor control, and replace what has worn.

  2. 2Loud rumble on spin

    Likely cause. Drum bearings that have let water in. The noise gets worse month by month.

    What you can check. Turn the empty drum by hand. Grinding or play up and down points to bearings.

    What we do. We confirm it and price the job honestly. On sealed-tub machines we will say if it is not worth doing.

  3. 3Water left in the drum

    Likely cause. A coin, hair grip or sock in the drain pump, a kinked outlet hose, or a pump motor that has burnt out.

    What you can check. Check the outlet hose behind the machine is not flattened, and that the sink waste it joins is running freely.

    What we do. We clear the pump housing, test the pump under load and fit a new one if the motor is weak.

  4. 4Water on the floor

    Likely cause. A torn door gasket, a perished hose, a blocked soap drawer overflowing, or a leaking pump seal.

    What you can check. Look for a tear in the grey door seal at the bottom, and pull the drawer out to see if it is caked.

    What we do. We trace the leak with the top and back off rather than guessing, then replace the failed seal or hose.

  5. 5Will not fill

    Likely cause. A closed tap, a blocked inlet filter or a failed inlet valve.

    What you can check. Make sure the tap on the cold feed is fully open and the hose is not trapped.

    What we do. We clean the inlet filter, test the valve coil and pressure switch, and replace the faulty part.

By make

Also in Cheam

Nearby

More about washing machine repairs

Questions we are asked

How soon can someone look at my washing machine in Cheam?

We are in the Cheam area on visit days from Monday to Thursday. Call 0208 462 2111 for the earliest slot, and have the model number to hand.

Do you fit new machines?

Our visits are for repairs. If a machine is beyond economic repair we will tell you before any money is spent on parts.

Is an eight-year-old washing machine worth repairing?

Often, yes. Pumps, locks, heaters and brushes are modest parts. Bearings on a sealed tub are the usual point at which we advise replacing instead.

Book a repair visit

Tell us the make, the model and what the appliance is doing. An engineer visits, finds the fault and agrees the price with you before repairing it.

Visits run Monday to Thursday across Sutton and the surrounding SM postcodes.