SuttonAppliance Engineers

Tumble dryer repairs in Cheam

Home visits for tumble dryer faults across Cheam and the rest of SM3, Monday to Thursday.

Call 0208 462 2111Book online

Heat pump tumble dryer standing in a utility room

Utility rooms are common in Cheam, with a separate washing machine and heat pump dryer stacked or side by side.

A dryer that runs cold has normally tripped a safety thermostat because air could not get through it. Finding out why matters as much as resetting it.

Cheam is built around the village crossroads and its timber-fronted shopping parades, with Nonsuch Park on one side and Cheam Park on the other.

Tumble dryer faults we are called to in Cheam

Tumble dryer with the fault locations numbered12345
Tumble dryer drawing. The numbers match the faults listed alongside.
  1. 1Takes hours to dry

    Likely cause. Restricted airflow: a clogged condenser, a blocked heat pump filter or a crushed vent hose.

    What you can check. On heat pump dryers, wash the lower foam filter and let it dry before refitting.

    What we do. We strip and clean the air path and test the humidity sensor.

  2. 2Stops after a few minutes

    Likely cause. Overheat cut-out operating, or a moisture sensor reading dry too early.

    What you can check. Wipe the two metal sensor strips inside the drum with white vinegar.

    What we do. We test the cut-outs and control and correct the cause.

  3. 3Drum does not turn

    Likely cause. A snapped drive belt, a seized tension pulley or a failed motor capacitor.

    What you can check. With the dryer off, turn the drum by hand. If it spins with no resistance the belt has gone.

    What we do. We fit a new belt and check pulley and motor while the cabinet is open.

  4. 4Runs but stays cold

    Likely cause. A tripped or failed thermostat, or a heater element that has broken.

    What you can check. Clean the door filter and, on condenser models, rinse the condenser unit.

    What we do. We test heater and thermostats, find why it overheated and replace the failed parts.

  5. 5Door will not stay shut

    Likely cause. A broken catch or a worn latch plate.

    What you can check. Check nothing is trapped in the seal.

    What we do. We fit a new catch and adjust the door.

By make

Also in Cheam

Nearby

More about tumble dryer repairs

Questions we are asked

Do you charge extra to come to Cheam?

Cheam is inside our normal working area. The engineer finds the fault on the visit and agrees the cost of the repair with you before starting.

How often should the condenser be cleaned?

About once a month under a tap. Heat pump dryers have a foam filter instead, which needs washing every few loads.

Is my dryer part of a safety recall?

Some older Hotpoint, Indesit and Creda dryers were recalled. Check the model on the maker's site. We repair dryers but cannot carry out a manufacturer's recall modification.

Book a repair visit

Tell us the make, the model and what the appliance is doing. An engineer visits, finds the fault and agrees the price with you before repairing it.

Visits run Monday to Thursday across Sutton and the surrounding SM postcodes.