SuttonAppliance Engineers

Washing machine repairs in Banstead

Home visits for washing machine faults across Banstead and the rest of SM7, Monday to Thursday.

Call 0208 462 2111Book online

Engineer working at the open door of a washing machine

Utility rooms in Banstead often hold a large-drum washer and a heat pump dryer, and sometimes a second washing machine.

Most of the machines we open in Sutton have failed in one of four places: the drain pump, the door lock, the heater or the motor. None of those is a reason to scrap a machine that is otherwise sound.

Homes here are larger on average than in the borough of Sutton, and kitchens are specified to match, with range cookers, banks of ovens and separate utility rooms.

Washing machine faults we are called to in Banstead

Washing machine with the fault locations numbered12345
Washing machine drawing. The numbers match the faults listed alongside.
  1. 1Water on the floor

    Likely cause. A torn door gasket, a perished hose, a blocked soap drawer overflowing, or a leaking pump seal.

    What you can check. Look for a tear in the grey door seal at the bottom, and pull the drawer out to see if it is caked.

    What we do. We trace the leak with the top and back off rather than guessing, then replace the failed seal or hose.

  2. 2Door will not open or lock

    Likely cause. A failed door interlock, a broken handle or catch, or water still in the drum.

    What you can check. Wait three minutes after the cycle ends before trying the handle again.

    What we do. We release the door without damaging it and fit a new interlock or handle.

  3. 3Will not fill

    Likely cause. A closed tap, a blocked inlet filter or a failed inlet valve.

    What you can check. Make sure the tap on the cold feed is fully open and the hose is not trapped.

    What we do. We clean the inlet filter, test the valve coil and pressure switch, and replace the faulty part.

  4. 4Cold wash, or trips the fuse board

    Likely cause. A heater element that has scaled up and failed to earth, or a faulty temperature sensor.

    What you can check. If the electrics trip, leave the machine unplugged until it has been tested.

    What we do. We insulation-test the heater, replace it with the sensor if needed and re-test for safety.

  5. 5Water left in the drum

    Likely cause. A coin, hair grip or sock in the drain pump, a kinked outlet hose, or a pump motor that has burnt out.

    What you can check. Check the outlet hose behind the machine is not flattened, and that the sink waste it joins is running freely.

    What we do. We clear the pump housing, test the pump under load and fit a new one if the motor is weak.

By make

Also in Banstead

Nearby

More about washing machine repairs

Questions we are asked

How soon can someone look at my washing machine in Banstead?

We are in the Banstead area on visit days from Monday to Thursday. Call 0208 462 2111 for the earliest slot, and have the model number to hand.

Do you fit new machines?

Our visits are for repairs. If a machine is beyond economic repair we will tell you before any money is spent on parts.

Is an eight-year-old washing machine worth repairing?

Often, yes. Pumps, locks, heaters and brushes are modest parts. Bearings on a sealed tub are the usual point at which we advise replacing instead.

Book a repair visit

Tell us the make, the model and what the appliance is doing. An engineer visits, finds the fault and agrees the price with you before repairing it.

Visits run Monday to Thursday across Sutton and the surrounding SM postcodes.